CatastrophiCreations Wall Mounted Cat Feeder
This wall-mounted cat feeder comes with a pint size food dish. It is a little longer then our dining room cat shelf at 20" long and 9.5" wide. We have a variety of stain colors to choose from.
These are very sturdy; our 17lb cat loves it. One of the brackets needs to be mounted into a stud, and we supply plastic drywall pieces to mount the other into drywall.
How much weight do the shelves hold?
We haven't actually maxed out the weight on our shelves yet, so it's hard to give an exact number. We have tested them at 54lbs, and they didn't budge. We use corner braces for brackets that are attached from the top, so that when weight is applied it pushes the shelf tight against the wall. That creates a very sturdy hold. They do need to have at least one of the brackets mounted into a stud. If you don't have studs avalible, then there is other possiblities like heavy duty dry wall anchors. Home depot has packs of 6 fthat are rated to each hold 65lbs for under $5.
All of our shelves only have one bracket mounted in studs. We've applied 45lbs on ours and they were fine. If I we're going to guess I would say about 50-55lbs would be pushing it.
What if I have no studs to install the shelves. Can they be installed into drywall or plaster?
If you don't have studs available, there are other possibilities, like heavy duty drywall anchors. Home depot has packs of six that are rated to each hold 65 lbs. for under five dollars.
We've never tried these with our raceways, or fabric play place. We're not sure that they would hold tight enough. They get pulled from the side each time a cat jumps on, so we really suggest mounting those into studs.
Do the shelves come with mounting equipment?
All of our pieces come with screws, light duty drywall anchors and brackets attached. Except for our cat bridge. Because it typically sits at a doorway, we don't know where the studs are, so we include brackets but do not attach them.
What do I need to mount the shelves?
You need a screw driver, a drill, and a stud finder.
Also a level, if you want them perfectly straight.
|Can be Customized|
|Made in the USA|